you can use ¹ the included 3,6mm gimlet or ² a 4mm drill bit
² makes it easier to follow my instructions, but you should seal the connections with elastic glue or latex paint
•BCY extend the 0,5mm venting holes
•M drill a hole @ the end of the 4th furrow, before the 1st long horizontal furrow.
Check with a needle the inner chamber wall. If you are not so experienced in drilling holes, drill @ the end of the 3rd furrow.
To remove plastic for the magenta connector head:
¹ put ink or paint on the connector head ² push the lid down ³drill @ the inked possition
It's better to drill the gap with the gimmlet than with a machine, it takes only ~ 1min
in some yt tutorials it looks easy to remove the clamp body, i was not able to do it.
No comments:
Post a Comment